Performance of aluminum foam cap machine

Performance of aluminum foam cap machine

Flat type aluminum-plastic bubble cap packing machine aluminum-plastic drum: includes two parts: aluminum-foil drum and plastic sheet drum. The drum is mainly composed of a cylinder body, inside and outside the stator, brake ring and adjusting nut, both ends of the cylinder body with rolling bearings on the supporting shaft, for the rotating part of the drum, when the traction of plastic film or aluminum foil, that is, to drive the roll material installed on the drum by the rotation. The stator is divided into inner and outer stators, which are sliding sleeve on the cylindrical surface outside the cylinder body and fixed at any position of the cylinder body by fixing screws to install and fix coils of different widths.

The brake ring is set on the inner and outer cylindrical surface of the cylinder body, and is fixed on the support plate. It is the static part of the drum and is used to brake the cylinder body. Tighten or withdraw the 4 adjusting screws on the outer circumference of the brake ring to increase or decrease the braking force on the cylinder body, so that the film or aluminum foil being pulled can obtain the necessary tensioning force. The adjusting nut can be installed on the supporting shaft and set in the outer end of the cylinder cylinder surface, and a bearing connected with the copper body, in the case of rotation of the cylinder, turn the adjusting nut, can make the cylinder to achieve axial movement, used to adjust the lateral position of the material. The supporting shaft is fixed on the strut, which is fixed on the fuselage to form the supporting body of the drum.