What should be paid attention to before the capsule filling machine is used?

What should be paid attention to before the capsule filling machine is used?

1, this equipment is a vibration machinery, should often check the fastening of all parts of the screw, if loose, should be tightened in time, to prevent failure and damage.

2, plexiglass parts (working table plate, medicine plate) should avoid direct sunlight and close to high temperature, can not use heavy objects, medicine plate must be placed vertically or flat, so as to avoid deformation and damage.

3. After finishing the work every day, the residual drugs in the machine and the mold hole should be cleaned to keep the machine clean and sanitary, and avoid flushing the main machine with water. If the mould needs to be cleaned on the machine, the fixing screw can be loosened to take it off. It is easy to install.

4, lock the reducer in the machine, the first time in the cumulative use of 24 hours to change the oil, the second time in the cumulative use of 72 hours to change the oil. After that, it will be replaced every few months.

5, the locking machine in the change of model as long as the rotation of the middle connecting rod will produce the pressure plate height difference, from 0# to 1#, 2# is to turn clockwise, so 2# to 1#, 0# is to turn counterclockwise. (1) When rotating the connecting rod, the connecting rod and the crankshaft must be vertical, that is, when the upper pressure plate is raised to a high position, the connecting rod and the crankshaft are also vertical, then it can be rotated. (2) the upper and lower screws of the connecting rod must be loosened before rotation. (3) Each rotation must be based on a 180 degree Angle to rotate. For example, one 180 degree Angle, two 180 degree Angle, three 180 degree Angle, no matter the reverse rotation, clockwise rotation as long as moving 180 degree Angle. Otherwise, when the machine is turned on, the reducer is damaged.

6. Replacement of the array type: (1) The incision of the rubber pellet is flat with the surface of the array plate. The adjustment part is the height of the transverse plate at both ends. The screw is in the long hole of the straight strut. (2) adjust the distance between the sliding plate and the movable plate. The spacing between the upper plate and the lower plate of the movable plate is 3 mm. Adjusting part in the box body of the two head screw and long tie rod. After the correct adjustment to tighten the screws, the foot rod and the box body under the horizontal edge close.

7, the arrangement plate and the activity plate must be misplaced (so the activity plate is also called the dislocation hole plate), when the sleeve plate is pushed into the end, the arrangement plate and the three plates of the hole plate should be aligned. If the hole position is not aligned, it is necessary to adjust the dislocation position of the active plate and the arrangement plate. Adjustment method: (1) loosen the screws of the straight support plate and the Angle support, and the straight support plate can drive the transverse plate and the movable plate into dislocation. (2) loosen the upper and lower screws of the shrapnel so that the assembly frame drives the arrangement plate into dislocation.