Check the capsule filling machine before use

Check the capsule filling machine before use

The machine is vibration machinery, should often check the screw fixation of each part. If it is loose, it should be tightened in time to avoid damage.

Plexiglass components (work table, cover plate) should avoid direct sunlight in high temperature, heavy objects should not be stacked. Cover plate should be vertical or flat to avoid deformation and damage.

At the end of each day, the machine and mold should be cleaned on the hole, keep the machine clean, avoid washing the main machine with water. If you need to clean the mold, please loosen the screws and take it down for easy installation.

Lock the reducer in. The first change is within 24 hours and the second within 72 hours. Then replace it once a month.

When the machine is locked in mold change mode, that is, the middle part of the rotation, the production plate height difference, 0#1#2 # is clockwise rotation, therefore, 2#1#0# is in the opposite direction of the clock. It should be emphasized here that the ring must be perpendicular to the crankshaft when rotating the ring, that is, when the roof rises to the highest height, the ring must also be perpendicular to the crankshaft in order to rotate. Loosen the upper and lower screws before turning. Each rotation should be based on a 180 degree Angle. One 180-degree Angle, two 180-degree angles, three 180-degree angles, whether you're going in the opposite direction, you just have to move one 180-degree Angle. Otherwise, the reducer will be damaged during startup.

Replace calibration model: Flatten the surface of the shot mouth and calibration plate. When the board is high or low, adjust the position horizontally at both ends. The screw is in the long hole on the right. Adjust the clearance between the shell thrust frame and the movable plate. The distance between the upper surface of the shell plate and the lower surface of the movable plate is 3mm. Adjust the position of the double - headed screw box and long pull rod. After tightening the screw, tighten the screw and tighten the foot bar on the lower side edge of the shell.

The mounting plate and removable plate must be moved and the removable plate and triple mounting plate must be fully aligned when the mounting plate is pushed to the bottom. If the orifice position is not aligned, the movable plate shall be adjusted to accommodate the orifice displacement.