Cleaning and finishing of blister packaging machine

Cleaning and finishing of blister packaging machine

Remove the waste PVC and aluminum foil rolls used by the blister packaging machine according to the installation procedure and collect them into the waste drums.

Unscrew the nut on the indentation plate, remove the indentation cover plate and place it on the operating table, unscrew the module fixing nut, wipe it clean with alcohol, then screw the nut and indentation cover plate back in order.

Clean the scraps scattered on the surface of the machine with a brush, collect them into the waste bucket, and wipe the surface of the machine clean with a wet cloth.

Wash and seal the upper and lower surfaces of the heating plate with steel wire brush twice a month.

After cleaning the special greasy spot, remove the residual detergent with a clean wet cloth and wipe it with a dry cloth.

Before starting each time, check whether the pressure of compressed air reaches the normal state, check whether the chiller works normally, check whether the temperature of each bearing is normal, and change the grease twice a year for each bearing.

Conduct monthly maintenance record and fill in the machine maintenance record.