Note for single stamping machine

Note for single stamping machine

According to the friction lubrication, is to ensure that the machine running and prolong the service life of the important link, especially the rapid drying of major sports if lack of oil transfer cause damage and cannot be used, so the machine before use all the oil cup, add lubricating oil hole, the friction surface, idle machine to make all the friction surface coated in oil can be used. In the future, regular refueling every shift, but each refueling should not be excessive, so as not to spill the influence of cleaning, stained tablets. Each refueling location and the number of refueling should be planned. :

Check whether all screws are loose before each shift, and pay attention to them when working. Tighten immediately to avoid failure. Its main components are: upper punch fixing nut, middle punch fixing screw, lower punch fixing screw; Locking nut and locking screw; Clamping nut, tension fixing screw for central grinding machine. Before and after each shift, the multiple tablets must be tested by manual pressure without any problem before turning on the electric compressor.

In the stamping process, should often check the mold quality, such as rimless, cracking, deformation and other serious damage, should be replaced in time, so as not to damage the machine, affect the quality of the plate.

After daily use, the residual dust particles should be removed and all departments of the machine should be cleaned. If there is a long down time, remove the mold and remove each friction surface of the machine. Clean the working surface, apply anti-rust oil and dust jacket; Molds should be cleaned and stored in oil.

Check the parts regularly, twice a month.