News Room
You are here: Home » News Room » PRODUCTS NEWS » Part operation of bubble cover packaging machine

Part operation of bubble cover packaging machine

Views: 1     Author: Site Editor     Publish Time: 2021-09-04      Origin: Site

Part operation of bubble cover packaging machine

PVC hard, aluminum foil volume installation: unload the film reel on the compression nut and the retaining sleeve, the PVC hard or aluminum foil volume set in the adjustment sleeve, installed on the retaining sleeve and the compression nut and screw compression nut, so that the film volume on the adjustment sleeve can not be loose and rotation; Loosen the back cap and turn the adjusting nut to align the CENTER of the PVC roll with the center of the heat sealing roll (250mm away from the body). When installing, measure the inner part of the roll from the body 125mm with the steel ruler; Adjust the brake screw tightness, PVC tension adjustment in 0.5~1kg tension, and aluminum foil tension adjustment in 1~2kg tension.

Placed PVC plastic belt, through the upper and lower heating plate mold to dividing the feed roller and pressure roller, after being met the requirement of the temperature and pressure, press the start button, at this point, the device delay 3 seconds to start, then should be based on positive pressure molding foam tape, after correction for dividing the location of the feed roller, the bubble into the feed roller of bubble nest inside, the distance between the second board, Press the upper roller and pull out the foam belt forming about two meters. When the upper and lower molds are separated, press the stop button to stop the machine. Use steel ruler to measure, when the bubble belt length after forming is the same as the circumference of the feed roller or about negative 1mm, then press the start button to try to blow the PVC plastic belt into a nest with a standard length of 4 meters, and prepare for the next road.

Bypass the guide roller to the filling platform, press the bubble cover into the socket eye of the hot sealing roller, press the pressure guide roller into the socket, lay the aluminum foil, and when the temperature of the roller reaches, rotate the hot sealing clutch knob to ON and press the start button to work. When the hot sealing aluminum foam belt is pulled out 1.5 meters, press the stop button to stop the machine.

泡罩包装机-2外

  info@hanyoo.net
  0086 25 5621 6295
  0086 25 5621 6289
  0086 187 5183 8183
  No. 380 Sanqiaogeng, Gaochun District,
Nanjing, China. 211300

Quick Link

Products

Leave a Message
Contact us

QR Code

Capsule Filling Machine, Blister Packing Machine
Copyright  2016 Jiangsu Hanyoo Pharmatech Co., Ltd. All rights reserved. Capsule Filling Machine, Blister Packing Machine, Cartoning Machine Professional Manufacture.