Views: 0 Author: Site Editor Publish Time: 2021-02-22 Origin: Site
Pay attention to the work of the tablet press
1. Before the use of the die must be strictly checked, there can be no cracks, missing edges and hair and other phenomena, such as forced use, it will bring damage to the machine.
2. The life of the die is generally produced one million times as the design basis. When overuse, the damage rate will be greatly increased, such as rupture will damage the feeder or other parts of the accident.
3. The feeder and the turntable table must maintain a certain gap, that is, 0. 05 1. 1 mm, the gap is too large to cause the leakage of powder, too small will make the feeder and the turntable table friction, resulting in metal powder mixed into the powder, so that the pressure out of the tablet does not meet the quality requirements, become scrap.
4. Not dry and high sugar content of the particles should not be pressed, so as not to produce sticky punch, resulting in the machine can not be normal production.
5. If the automatic stop alarm is found, turn off the power immediately and check carefully. It may be that the working pressure on the site has exceeded the set working pressure.
6. In case of jumping, overlapping or blocking pieces during operation, do not touch them by hand to avoid injury accidents, and stop for inspection.
7. For the safety of the operator, the grounding wire should be connected before the power supply is connected after the installation machine is in position to ensure safety.
8. The choice of speed has a direct impact on the service life of the machine. Due to the difference in the nature of raw materials, viscosity, sheet diameter and pressure size, it can not be uniformly stipulated in use. Generally speaking, the tablet speed of large diameter, high pressure, special-shaped piece, double-layer piece and difficult to form particles should be low, and the speed is higher on the contrary.