Tablet press in die top wire does not work how to do

Tablet press in die top wire does not work how to do

(1) in the process of use, punching rod hole and die hole due to different degrees of wear will likely appear different axial phenomenon, so that the punching rod moving up and down friction resistance increases, serious causes can not be normal tablet pressing. In view of this situation, if the production task is tight, the punching die hole can be temporarily blocked by the method of maintaining production, until the production task is not tight, and then maintenance. If the wear is not very serious, the coaxiality can be restored by using reamer to punch the rod hole, and the rotary table needs to be replaced when the wear is serious.

(2) the upward movement of the turntable is generally caused by the loosening of the taper locking block of the fixed turntable, which can be solved by fastening.

(3) the upward movement of the middle die is mostly caused by the loosening of the top wire of the middle die, which is solved by fastening the top wire of the middle die.

(4) the top wire of the middle die is a wearing part. It can not fasten the middle die due to long-term wear and should be replaced in time.