The turntable of the tablet press

The turntable of the tablet press

The turntable of the rotary press is a disk, in which the rod holes and the intermediate die holes are evenly distributed on the whole circumference. With the rotation of the spindle, each impact rod moves up and down along the curved guide rail to complete the tablet pressing process. The turntable is the main working part of the tablet press. Analyze and solve common faults during continuous operation:

(1) and intermediate stem hole die because of long time wear two hole alignment is not in conformity with the specification: in the process of work, the friction resistance may occur as a result of the different coaxial phenomenon, make transmission punch moving up and down friction increases, increase due to drive down rod between the different wear phenomena may occur in use process, can lead to can't normal operation. In less severe wear, the rod's coaxiality can be restored by drilling through the hinge, and in very severe wear, the turntable must be replaced.

(2) The rotation motion of the work table affects the packing or outlet work. The rotation motion of the work table is usually fixed on the work table by setting the conic lock block, which can be solved smoothly. If there is a problem with the fasteners, please replace them immediately.

(3) The loose wire rope at the top of the middle die causes the upward movement of the middle die and causes the wear of the feeder. The movement of the middle die is mainly caused by the wire rope at the top of the middle die. Fixed the thread on the intermediate die. The upper thread of the intermediate die is a worn part. The intermediate die cannot be fixed for a long time, it should be replaced in time.