Vacuum separator adjustment of capsule filling machine

Vacuum separator adjustment of capsule filling machine

The vacuum separator moves up and down once for each working station of the machine. The working position of the vacuum separator has been adjusted when the product leaves the factory, and there is no need to adjust it generally. If need to adjust can be divided into two vacuum separator adjustment at the same time and respectively adjustment of two methods; Adjustment method is to use the handle at the same time turn the main motor shaft, making vacuum separator to rise to higher position, loosen the machine panel under the lock nut on the end of a regulating rod (left, right screw thread) turn adjusting screw to adjust the height of the vacuum separator, (its separation module under the plane and the plane of the clearance of 0 ~ 0.03 mm) and then lock nut and the reinspection do not coincide several times, until the right. If there are two vacuum separators in the high point, the clearance between the two upper planes and the two lower planes of the lower module is inconsistent. To be adjusted separately; The method of adjustment is as follows: turn the shaft of the main motor with the handle to make the vacuum separator rise to a high position, loosen the fastening screws on the horizontal bar to be adjusted under the machine panel, then move the tapet of the suction capsule up and down, adjust the height of the vacuum separator, and tighten the screws. Then put the empty capsule into the capsule feeding device, start the vacuum pump, and turn the machine with the handle to confirm whether the capsule separating is normal.